LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (CVT Transaxle) >> Front Wheel Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Wheel Speed Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Be sure to prevent water or oil from contacting the connector terminal of front wheel speed sensor. If adhesion occurs, replace with a new part.
  • When removing front wheel speed sensor, CVTF may let out. If CVTF has leaked, adjust the CVTF level after installing the front wheel speed sensor.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Clean the transmission exterior.
  4. Remove the front wheel speed sensor harness connector.
  5. Remove the front wheel speed sensor.
    G10268156Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals