LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (CVT Transaxle) >> Rear Wheel Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Wheel Speed Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Clean the transmission exterior.
  4. Remove the bolts which connect the center exhaust pipe (rear) and rear exhaust pipe.
  5. Remove the bolts holding the center exhaust cover, and move the center exhaust cover to the rear.
  6. Disconnect the rear wheel speed sensor connector.
  7. Remove the rear wheel speed sensor.
    G10268159Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals