LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle >> Inhibitor Switch >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inhibitor Switch: Removal

  1. Shift the select lever to "N" range.
  2. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  3. Lift up the vehicle.
  4. Remove the snap pin and washer, and disconnect the select cable.
    CAUTION: Do not apply extra overload while holding the part (A).
    G11255302Courtesy of SUBARU OF AMERICA, INC.
    G13260909Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the spring pin and shifter arm.
    G13260910Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the inhibitor harness connector from inhibitor switch.
  7. Remove the two inhibitor switch securing bolts.
    G07913384Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the inhibitor switch.
scientia non olet · About LEMON Manuals