Section 33 (Entertainment System): Audio: Removal

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Remove the grille ventilation assembly center. Ref. to AIR CONDITIONER>Air Vent Grille>REMOVAL>CENTER GRILLE ASSEMBLY .
Remove the switch assembly hazard. Ref. to LIGHTING SYSTEM>Hazard Switch>REMOVAL .
Remove the audio assembly.
1. Remove the screws.
2. Release the clips and disconnect the connector, and then remove the audio assembly.
Courtesy of SUBARU OF AMERICA, INC.

NOTE: For models with telematics, the data communication module is attached on the upper side of the audio assembly.
Remove the backup unit. Ref. to SECURITY AND LOCKS>Backup Unit>REMOVAL .
Remove the data communication module. Ref. to ENTERTAINMENT & MONITORING>Data Communication Module>REMOVAL>DATA COMMUNICATION MODULE .
Remove the audio bracket.
1. Remove the screws, and then remove the audio bracket.

Courtesy of SUBARU OF AMERICA, INC.

NOTE: Remove the screws on LH side in the same procedure as on the RH side.