Operating Cylinder: Installation
- Install the operating cylinder.NOTE: Before installing, apply grease to the contact point of the release lever and operating cylinder.
Grease
NICHIMOLY N-130 or equivalent
Tightening torque:
37 N.m (3.8 kgf-m, 27.3 ft-lb)
- Replace the gasket with a new part, and install the clutch hose.CAUTION:
- Be sure to install with the mark side facing upward.
- Do not twist the parts during installation.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
(A) Clutch hose (B) OPERATING CYLINDER (C) Mark - After bleeding air from the operating cylinder, ensure that the clutch operates properly. Ref. to CLUTCH SYSTEM>CLUTCH FLUID AIR BLEEDING>PROCEDURE .
- Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .