April 5, 2026: LEMON Manuals is launched! Read the announcement.

Primary Pressure Sensor: Inspection

WARNING: This page is about a different variant/trim than selected.

Check for oil leaks.
Check [Primary Pressure Sensor Voltage.] of the primary pressure sensor.
1. Connect the Subaru Select Monitor.
2. Turn the ignition switch to ON. (Engine OFF)
3. Display [Primary Pressure Sensor Voltage.].
4. Start the engine and warm up completely.
5. Shift the select lever to "D range".
6. Shift the select lever to "P range".
7. Check [Primary Pressure Sensor Voltage.] with the vehicle idling.
  Specification:
  
  Approx. 0.6 V
8. Stop the engine.
9. Turn the ignition switch to ON. (Engine OFF)
10. Check [Primary Pressure Sensor Voltage.].
  Specification:
  
  Approx. 0.5 V