How To Proceed With Troubleshooting
- Vehicle Brought to Workshop
- Customer Problem Analysis (See CUSTOMER PROBLEM ANALYSIS CHECK ) .
- Connect the OBD II scan tool or hand-held tester to DLC3
- Check and Clear DTC and Freeze Frame Data (See PRE-CHECK )
- Visual Inspection
- Setting the Check Mode Diagnosis (See PRE-CHECK )
- Problem Symptom Confirmation
Symptom does not occur: Go to step 8
Symptom occur: Go to step 18
- Symptom Simulation (See HOW TO PROCEED WITH TROUBLESHOOTING ).
- DTC Check (See PRE-CHECK
)
DTC is not output: Go to step 10
DTC is output: Go to step 18
- Basic Inspection (See PRE-CHECK
)
NG: Go to step 20
OK
- Mechanical System Test (See PRE-CHECK
)
NG: Go to step 16
OK
- Manual Shifting Test (See PRE-CHECK
)
NG: Go to step 14
OK
- Problem Symptoms Table Chapter 1 (See PROBLEM SYMPTOMS TABLE
)
NG: Go to step 19
OK
- Problem Symptoms Table Chapter 2 (See PROBLEM SYMPTOMS TABLE
)
NG: Go to step 16
OK
- Problem Symptoms Table Chapter 3 (See PROBLEM SYMPTOMS TABLE
)
NG
Part Inspection
Go to step 20
- DTC Chart (See DIAGNOSTIC TROUBLE CODE CHART )
- Circuit Inspection (See DTC P0750 SHIFT SOLENOID A MALFUNCTION )
- Identification of Problem
- Repair
- Confirmation Test
End