LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2003 >> Matrix Base, 4WD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal & Installation 4-Cylinder >> Ignition Systems >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

  1. Install crankshaft position sensor. Install and tighten crankshaft position sensor bolts to specification. See TORQUE SPECIFICATIONS .
  2. To install remaining components, reverse removal procedure using NEW gaskets.
  3. On models equipped with 2ZZ-GE engine, note intake manifold bolt/nut identification before tightening intake manifold bolts/nuts to specification. See Figure. On all models, ensure gasket for throttle body is installed with protrusion area facing proper direction. See THROTTLE BODY  under FUEL SYSTEMS. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS .
  4. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING  under COOLING SYSTEM.
Fig 1: Locating Crankshaft Position Sensor (Celica, Corolla, Matrix, MR2 & RAV4)
G98J01626Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002


  1. Install crankshaft position sensor. Install and tighten crankshaft position sensor bolts to specification. See TORQUE SPECIFICATIONS .
  2. To install remaining components, reverse removal procedure using NEW gaskets. Ensure gasket for throttle body is installed with protrusion area facing proper direction. See THROTTLE BODY  under FUEL SYSTEMS. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS .
  3. Fill cooling system.
scientia non olet · About LEMON Manuals