How To Proceed With Troubleshooting
WARNING: This page is about a different variant/trim than selected.
- Vehicle Brought to Workshop
- Customer Problem Analysis (See CUSTOMER PROBLEM ANALYSIS CHECK )
- Connect the OBD II scan tool or hand-held tester to DLC3
- Check and Clear DTC and Freeze Frame Data (See PRE-CHECK )
- Visual Inspection
- Setting the Check Mode Diagnosis (See PRE-CHECK )
- Problem Symptom Confirmation
- Symptom Simulation (See HOW TO PROCEED WITH TROUBLESHOOTING )
- DTC Check (See PRE-CHECK )
- Basic Inspection (See PRE-CHECK
)
- NG: Go to 19
- OK: Go to next step
- Mechanical System Test (See PRE-CHECK
)
- NG: Go to 16
- OK: Go to next step
- Manual Shifting Test (See PRE-CHECK
)
- NG: Go to 14
- OK: Go to next step
- Problem Symptoms Table Chapter 1 (See PROBLEM SYMPTOMS TABLE
)
- NG: Go to 18
- OK: Go to next step
- Problem Symptoms Table Chapter 2 (See PROBLEM SYMPTOMS TABLE
)
- NG: Go to 16
- OK: Go to next step
- Problem Symptoms Table Chapter 3 (See PROBLEM SYMPTOMS TABLE
)
- NG: Go to next step
- Part Inspection
- Go to 19
- DTC Chart (See DIAGNOSTIC TROUBLE CODE CHART )
- Circuit Inspection (See DTC P0750 SHIFT SOLENOID A MALFUNCTION )
- Identification of Problem
- Repair
- Confirmation Test
- End