LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Cruise Control Systems) >> System Tests >> Test No. 8: Set Possible At 25 Mph Or Less, Or Cancel Does Not Operate At 25 Mph Or Less
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test No. 8: Set Possible At 25 Mph Or Less, Or Cancel Does Not Operate At 25 Mph Or Less

WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check cruise control actuator control cable adjustment. See CRUISE CONTROL ACTUATOR CONTROL CABLE  under ADJUSTMENTS. If cruise control actuator control cable adjustment is okay, go to next step.
  2. Check vehicle speed sensor. See DTC 23: VEHICLE SPEED SENSOR SIGNAL ABNORMAL  test under DIAGNOSTIC TESTS. If vehicle speed sensor is okay, go to next step.
  3. Check cruise control actuator. See DTC 11: SHORT IN CRUISE CONTROL ACTUATOR CIRCUIT OR DTC 15: OPEN IN CRUISE CONTROL ACTUATOR CIRCUIT  test under DIAGNOSTIC TESTS. If cruise control actuator is okay, go to next step.
  4. Turn ignition off. Disconnect cruise control ECU 16-pin electrical harness connector. Using DVOM, check cruise control ECU ground circuit. See CRUISE CONTROL in SYSTEM WIRING DIAGRAMS article. If ground circuit is faulty, repair and retest system. If ground circuit is okay, substitute original cruise control ECU with a known-good unit and recheck system operation. If system operates properly, original cruise control ECU was defective. If system still does not operate properly, perform cruise control ECU pin voltage check. See PIN VOLTAGE TESTS . Check wiring harness and electrical connectors for an intermittent problem. Repair wiring harnesses or connectors as necessary. See CRUISE CONTROL in SYSTEM WIRING DIAGRAMS article. If voltage values, harnesses and connectors are okay, replace cruise control ECU. See CRUISE CONTROL ELECTRONIC CONTROL UNIT  under REMOVAL & INSTALLATION. After repairs, perform confirmation test. See CONFIRMATION TEST .