Test sequence (vehicles with 09A transmission): Notes

WARNING: This page is about a different variant/trim than selected.

Fig 1: Disconnecting Connector Off Wire For Multifunction Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Observe safety precautions. Refer to Safety precautions .

If harness connector is not OK:

Repair the malfunction.
Erase DTC memory of Transmission Control Module (TCM). Refer to Diagnostic mode 4: Reset/erase diagnostic data
Generate readiness code. Refer to Readiness code, generating

If harness connector is OK:

Check wire for Ground (GND) refeed of valve body according to wiring diagram. Refer to Checking Ground (GND) refeed of valve body .