3.2.2 Adaptive Cruise Control Module, Removing And Installing, From Retaining Plate

Special Tools And Workshop Equipment Required

Removing

Remove the Distance Regulation Control Module - J428-. Refer to 3.2.1 Adaptive Cruise Control Module, Removing And Installing, With Retaining Plate
Turn the quick-release fasteners -2- in the direction of the -arrow-.
Remove the retaining plate -3- from the Distance Regulation Control Module - J428- -4-.
Remove the quick-release fasteners -2- from the adjusting screws -1-.

Installing

Install in the reverse order of removal. Note the following:

NOTE:

Replace the quick-release fasteners -2-.
The adjusting screws -1- in the adapter frame are preset. If necessary, correct the setting. Refer to figure below or Fig 1

Fig 1: Adjusting Screw

Adjusting Screw Adjusting

Using the -VAS6335- measure the adjustment dimension -a- on all adjusting screws and adjust if necessary.
- Dimension -a- = 40.3 mm ± 0.5 mm
Push in new quick-release fasteners -2- on the adjusting screws and fixed bearing on the adapter frame -3-.
Install the retaining plate -1- on the quick-release fasteners -2-.
Turn the quick-release fasteners -2- on the back of the retaining plate -1- in the direction of -arrow A- until stop.
Install the Distance Regulation Control Module - J428-. Refer to 3.2.1 Adaptive Cruise Control Module, Removing And Installing, With Retaining Plate
Calibrate the adaptive cruise control. Refer to 3.3 Adaptive Cruise Control, Calibrating