Installing Removed Components

Install: 

• the heated oxygen sensor (HO2S) connector
• the rubber mountings for the exhaust pipe
• SIPS (side impact protection system) member
• the four screws for the SIPS (side impact protection system) member. Tighten to 24 Nm  .

Route the hose for the EVAP canister to the correct position and press the joints together

Install the four nuts and the screw holding the steering gear. Use new nuts and a new screw. Tighten to 50 Nm  .

Clip the cable in position.

Install: 

• the ball joints. Use new nuts. Tighten to 80 Nm  . Counterhold using a Torx wrench so that the ball joint boot is not damaged
• the anti-roll bar links. Use new nuts. Tighten to 50 Nm  . Counterhold using a Torx wrench so that the boot is not damaged.

Install: 

• the lower torque rod. Tighten the two screws. Tighten to 10 Nm 
• the oil pipe for the steering gear from the snap fasteners along the sub-frame
• the screw clip for the steering gear return line
• the engine block heater and the fuel line to the engine block heater if applicable
• the screw for the cable duct
• the screw for the ground lead.