Lateral Acceleration Sensor
CAUTION:
DO NOT damage or drop the sensor as it is sensitive.
CAUTION:
DO NOT use an impact wrench. For accurate reading, the vehicle must be level.
- Remove the sensor canter console panel. Remove the lateral acceleration sensor from the left lower side with the connector connected. See Fig 1 .
- Turn the ignition switch on. Measure the voltage between the lateral acceleration sensor 3 Pin connector terminal No. 2 and body ground. See Fig 2
.
- When the connector side is level, the voltage is about 2.5 volts.
- When the connector side is facing up, the voltage is about 3.5 volts.
- When the connector side is facing down, the voltage is about 1.5 volts.
- If the voltage is not as specified, replace the lateral acceleration sensor. After replacing the lateral acceleration sensor, perform the Neutral Position Memorization. See STEERING ANGLE SENSOR NEUTRAL POSITION CHECK & MEMORIZING under PROGRAMMING.