Engine Control Module
Service Precautions
Description and Operation
Testing and Inspection- Initial Inspection and Diagnostic Overview
- Component Tests and General Diagnostics
- General Information
- Air Flow Meter (HLM)
- CO Potentiometer (At HLM)
- Control Unit Voltage Supply
- Defect Lamp "Check Engine" (US Only)
- Engine Temperature Sensor (Coolant)
- Engine-Speed/Position Pulse Generator
- Fuel Evaporation Valve
- Fuel Injector Valves
- Idle/Full Load Signal
- Ignition Coil
- Intake Air Temperature Sensor (In Air Flow Meter)
- Main Relay - Control (DME Relay 2)
- Oxygen Control
- Oxygen Sensor
- Pulse Generator - Cylinder Reference Point
- Sensor Heating Relay
- TR Signal /EKP Relay (Electric Fuel Pump)
- Programming and Relearning
Locations
Service and Repair
Diagrams- Diagram Information and Instructions
- Wire Color Code Identification
- Component ID (General List)
- Front Power Distribution
- Fuse Information
- Fuse Chart
- Fuse Details
- Fuses 1, 2, 3, 4, and 5
- Fuses 6 and 7
- Fuses 8 and 9
- Fuses 10, 11, 12 and 13
- Fuses 14, and 15
- Fuses 16, 17, 18 and 19
- Fuses 20, 21 and 22
- Fuse 23
- Fuse 24 and 25
- Fuses 26, 27, 28, 29, and 30
- Fuse 31
- Fuses 32 and 33
- Fuses 34. 35, 36, 37, 38 and 39
- Fuses 40, 41 and 42
- Fuse 43
- Fuse 44
- Fuse 45
- Fuse 46
- Fuse 47, 48, 49 and 50
- Ground Distribution
- Introduction
- Symbol Identification
- Connector Views
- Electrical Diagrams
- Diagram Information and Instructions
Specifications
Technical Service Bulletins