LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1999 >> LHS >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Memory System Test 24A >> Left Heated Seat Switch Stuck In High State
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Left Heated Seat Switch Stuck In High State

NOTE: Perform MEMORY SYSTEM TEST 1A  before proceeding with this test. For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER - INTRODUCTION. Perform VERIFICATION TEST: VER-4A  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Disconnect left seat heater switch 6-pin connector. Using scan tool, erase DTCs. Turn ignition off. Turn ignition on. Using scan tool, read DTCs. If LEFT HEATED SEAT SWITCH OPEN/SHORTED TO GROUND fault message is present, replace seat heater switch. If LEFT HEATED SEAT SWITCH OPEN/SHORTED TO GROUND fault message is not present, go to next step.
  2. Disconnect Memory Heated Seat/Mirror Module (MHSMM) 16-pin harness connector. MHSMM is located under front of seat. See Figure. Using voltmeter, measure voltage between ground and terminal No. 6 (Tan/Dark Green wire) on left seat heater switch harness connector. If voltage is greater than .2 volts, repair Tan/Dark Green wire for short to voltage. If voltage is .2 volts or less, replace MHSMM.
scientia non olet · About LEMON Manuals