Removal and Installation (AWD Models): Installation

Install the removed parts in the reverse order of the removal, while paying attention to the following work.

When installing A/T assembly to the engine assembly, attach the fixing bolts in accordance with the following standard.

BOLTS SPECIFICATIONS

Bolt No.	1	2	3	4
Number of bolts	1	5	2	1
Bolt length "l " mm (in)	55 (2.17)	65 (2.56)	35 (1.38)	40 (1.57)
Tightening torque N.m (kg-m, ft-lb)	75 (7.7, 55)		47 (4.8, 35)	34 (3.5, 25)

Fig 1: Identifying Transmission Bolt Dimension

Align the positions of tightening bolts for drive plate with those of the torque converter, and temporarily tighten the bolts. Then, tighten the bolts with the specified torque. Refer to "COMPONENTS ".

Fig 2: Aligning Positions Of Tightening Bolts For Drive Plate

CAUTION:

When turning crankshaft, turn it clockwise as viewed from the front of the engine.
When tightening the tightening bolts for the torque converter after fixing the crankshaft pulley bolts, be sure to confirm the tightening torque of the crankshaft pulley mounting bolts. Refer to "INSTALLATION ".
After converter is installed to drive plate, rotate crankshaft several turns and check to be sure that A/T rotates freely without binding.

Install crankshaft position sensor (POS). Refer to "REMOVAL AND INSTALLATION (AWD MODELS) ".
After completing installation, check A/T fluid leakage, A/T fluid level and A/T position. Refer to "CHECKING A/T FLUID ", "CHECKING OF A/T POSITION ".