Work Procedure
Always perform the lane camera unit configuration and adjust the camera aiming after removing and installing or replacing the lane camera unit.
CAUTION:
The system does not operate normally unless the camera aiming adjustment is performed. Always perform it.
- LANE CAMERA UNIT CONFIGURATION
Perform the lane camera unit configuration with CONSULT. Refer to Work Procedure .
>>
GO TO 2.
- CAMERA AIMING ADJUSTMENT
Perform the camera aiming adjustment with CONSULT. Refer to Work Procedure .
>>
GO TO 3.
- PERFORM SELF-DIAGNOSIS
Perform the self-diagnosis of lane camera unit with CONSULT. Check if any DTC is detected.
Is any DTC detected?
YES>>
Perform the trouble diagnosis for the detected DTC. Refer to DTC Index .
NO>>
GO TO 4.
- CHECK FEB SYSTEM SETTING
- Start the engine.
- Check that the FEB system setting can be enabled/disabled on the combination meter.
>>
WORK END.