How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the vehicle stability control system.
• *: Use Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK AND CLEAR DTC* 
4. PROBLEM SYMPTOM CONFIRMATION 

   Result 

   DTC RESULT DESCRIPTION
   
   

   Result	Proceed to
   Symptom does not occur	A
   Symptom occurs	B

   B: Go to step   7

   A: Go to next step. 

5. SYMPTOM SIMULATION 
6. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)* 
   1. Use Techstream to check for normal functioning of the CAN communication system.
      1. Perform bus check (communication malfunction DTC).

         Result 

         DTC RESULT DESCRIPTION
         
         

         Result	Proceed to
         DTC is not output	A
         DTC is output	B

   B: Go to CAN COMMUNICATION SYSTEM

   A: Go to next step. 

7. CHECK FOR DTC* 

   Result 

   DTC RESULT DESCRIPTION
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   B: Go to step  10

   A: Go to next step. 

8. PROBLEM SYMPTOMS TABLE 

   Result 

   DTC RESULT DESCRIPTION
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step   10

   A: Go to next step. 

9. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Terminals of ECU (see TERMINALS OF ECU  )
   2. Data List / Active Test (see DATA LIST / ACTIVE TEST  )

   NEXT: Go to step   11

10. CHECK FOR FLUID LEAKAGE 
11. REPAIR OR REPLACE 
12. CONFIRMATION TEST 

    NEXT: END