LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1996 >> Eclipse Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Symptom Id Test 1A - Identifying Vehicle Equipment & System Problems
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Symptom Id Test 1A - Identifying Vehicle Equipment & System Problems

WARNING: This page is about a different car, the 1995 Dodge Stratus and 1995 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . When directed to go to next step, disregard step if vehicle is not equipped with module being tested.
NOTE: Perform a visual inspection before proceeding with this test.
  1. Connect scan tool to Chrysler Collision Detection (CCD) Bus Data Link Connector (DLC). DLC is a 16-pin connector located on left side kick panel, just above hood release. Turn ignition switch to ON position. If scan tool display is not blank, go to next step. If scan tool display is blank, go to NO RESPONSE TEST 5A  .
  2. Using scan tool, select BODY SYSTEM, then BODY COMPUTER. Scan tool will perform a CCD bus test. If scan tool displays BUS FAILED, see BODY CONTROL COMPUTER. If scan tool displays NO RESPONSE, go to NO RESPONSE TEST 1A  . If scan tool does not display BUS FAILED or NO RESPONSE, go to next step.
  3. Using scan tool, select INPUT/OUTPUT and read ign run/start status. If scan tool displays OPEN, go to NO RESPONSE TEST 1A. If scan tool does not display OPEN, go to next step.
  4. Using scan tool, select READ DTCs. If any Diagnostic Trouble Codes (DTCs) are present, go to TEST 1B, IDENTIFYING DTCs. If no DTCs are present, go to SYMPTOM ID TEST 1A DIAGNOSTIC TEST DIRECTORY for specific diagnosis.
SYMPTOM ID TEST 1A DIAGNOSTIC TEST DIRECTORY

Problem (1) Perform
Chime System CHIME TEST 1A
Door Ajar System DOOR AJAR TEST 1A
Exterior Lighting System EXTERIOR LIGHT TEST 1A
Interior Lighting System INTERIOR LIGHT TEST 1A
Instrument Cluster INSTRUMENT CLUSTER TEST 1A
A/C System (2) *
Power Door Lock System POWER DOOR LOCK TEST 1A
Vehicle Theft Security System VTSS TEST 1A
Windshield Wiper System WINDSHIELD WIPER TEST 1A
(1) The problems listed are diagnosed using a scan tool. These problems may occur separately or in various combinations. When diagnosing a system with many apparent problems, a sequence of tests may be required. At the beginning of each test a note will indicate which test to perform first. After repairs, ensure problem(s) or failure(s) have been corrected.
(2) For problems or failures relating to A/C system, see appropriate article in the AIR CONDITIONING & HEATING section.