Work Procedure
WARNING: This page is about a different car, the 2020 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
BEFORE REPLACEMENT
When replacing sonar control unit, save or print current vehicle specification with CONSULT configuration before replacement.
NOTE:
If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing sonar control unit.
AFTER REPLACEMENT
CAUTION:
When replacing sonar control unit, you must perform "After Replace ECU" with CONSULT.
- Complete the procedure of "After Replace ECU" in order.
- If you set incorrect "After Replace ECU", incidents might occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
- SAVING VEHICLE SPECIFICATION
CONSULT
Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.
NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing sonar control unit.GO TO 2.
- REPLACE SONAR CONTROL UNIT
Replace sonar control unit. Refer to Removal and Installation .
GO TO 3.
- WRITING VEHICLE SPECIFICATION
- Enter "Re/Programming, Configuration".
- If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to Work Procedure .
- If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .
GO TO 4.
- OPERATION CHECK
Check that the operation of the sonar control unit and camera images (fixed guide lines) are normal.
Work End.