Work Procedure

PERFORM VCM RECOMMUNICATING FUNCTION
1. Install VCM.
2. Contact backside of registered Intelligent Key* to power switch while brake pedal is depressed, then press power switch to the ON position.
  *: To perform this step, use the key that is used before performing VCM replacement.
3. Maintain power switch in the ON position for at least 5 seconds.
4. Power switch to the OFF position.
5. Check that the vehicle can be set to READY.
GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING VCM
Refer to Work Procedure .

Inspection End.