LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2021 >> Sentra S >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Intelligent Around View Monitor System >> Basic Inspection >> Additional Service When Replacing Around View Monitor Control Unit >> Work Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure

  1. SAVING VEHICLE SPECIFICATION 

    SYMBOL CONSULT

    Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

    NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing around view monitor control unit.

    GO TO 2.

  2. REPLACE AROUND VIEW MONITOR CONTROL UNIT 

    Replace around view monitor control unit. Refer to Removal and Installation .

    GO TO 3.

  3. WRITING VEHICLE SPECIFICATION 

    SYMBOL CONSULT

    1. Enter "Re/Programming, Configuration".
    2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to Work Procedure .
    3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

    GO TO 4.

  4. OPERATION CHECK 

    Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.

    Work End.

scientia non olet · About LEMON Manuals