How To Proceed With Troubleshooting

HINT:

• Use this procedure to troubleshoot the push button start function.
• The hand-held tester should be used in steps 3, 4 and 6.
• When troubleshooting the push-button function using the hand-held tester with the engine switch off, connect the hand-held tester to the vehicle and repeat turning any of the courtesy light switches on and off until communication between the tester and the vehicle begins (the interval between ON and OFF should be less than 1.5 sec.).

1. VEHICLE BROUGHT TO WORKSHOP 
   1. NEXT: Go to next step. 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (SEE  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
   1. NEXT: Go to next step. 
3. INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN) 
   1. Use the hand-held tester to check for normal function of the multiplex communication system.
      1. (ECU not connected, communication line malfunctioning) Without code outputs, proceed to A.
      2. (ECU not connected, communication line malfunctioning) With code outputs, proceed to B.
   1. B: Go to MULTIPLEX COMMUNICATION SECTION (SEE  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
   2. A: Go to next step. 
4. CHECK DTC (SEE  DTC CHECK/CLEAR  ) 
   1. Check for DTCs and note any codes that are output.
   2. Delete the DTC.

      HINT:

      After DTCs are all cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).

   3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
      1. If the DTC does not reoccur, proceed to A.
      2. If the DTC reoccurs, proceed to B.
   1. B: DTC CHART (SEE  DIAGNOSTIC TROUBLE CODE CHART  ) 
   2. A: Go to next step. 
5. INSPECT BASIC OPERATION 
   1. Turn the engine switch on (START) and check that the engine starts normally. Make sure the brake pedal is depressed and the shift position is in P at this time.
   2. Check that the engine switch mode can be changed by pushing the engine switch.

   HINT:

   Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from OFF to ON (ACC) to ON (IG) and back to OFF.

   With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.

   OK: Engine can start normally 

   1. NEXT: Go to next step. 
6. PROBLEM SYMPTOMS TABLE (SEE  PROBLEM SYMPTOMS TABLE  ) 
   1. If the fault is not listed in the problem symptoms table, proceed to A.
   2. If the fault is listed in the problem symptoms table, proceed to B.
   1. B: Go to step   8 
   2. A: Go to next step. 
7. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Data List/Active Test (see DATA LIST/ACTIVE TEST )
      1. Inspection with the hand-held tester (Data List)
      2. Inspection with the hand-held tester (Active Test)
   2. Terminal of ECU (see TERMINALS OF ECU )
   1. NEXT: Go to next step. 
8. ADJUST, REPAIR OR REPLACE 
   1. NEXT: Go to next step. 
9. CONFIRMATION TEST 
   1. NEXT: END