On Board Diagnostics - 5.0L V8
- 2 Introduction
- Diagnostic Trouble Codes
- 3 Mode $06 Data
- 3.1 Functional Description
- Notes
- 3.1.1 Reporting of On-Board Diagnostic Monitor ID test values in response to $06 $00 request
- 3.1.2 Reporting of On-Board Diagnostic Monitor ID test values in response to $06 $01 - $FF request
- 3.1.3 Unit and Scaling ID definition
- 3.1.4 Test Result Description
- 3.1.5 Using Table 5
- 3.1.6 Example for Use of Standardised Test IDs for Misfire Monitor
- 3.1 Functional Description
- 4 Onboard Monitoring
- 4.1 Catalyst Monitoring
- 4.2 Misfire Monitoring
- 4.2.1 Description
- 4.2.2 Misfire Monitor Process Hierarchy
- 4.2.3 Strategy Description
- Introduction
- Recording segment time and position, and its manipulation
- Adjustment of crank angle tolerance
- Misfire 'signal' calculation
- Misfire judgement
- Catalyst damage judgement
- Storing adaption values in back-up memory
- Excess emissions judgement
- Monitor execution check
- Adaptive learning execution check
- Rough road and low fuel level judgement
- 4.2.4 Misfire Malfunction Criteria
- 4.2.5 Misfire Enable Criteria
- 4.3 Evaporative Emission System Monitoring
- 4.4 Fuel System Monitoring
- 4.5 Oxygen Sensor Monitoring
- 4.5.1 Upstream Heated Oxygen Sensor Slow Response - P0133, P0153
- 4.5.2 Upstream Heated Oxygen Sensor Slow Activation - P0134 and P0154
- 4.5.3 Downstream Oxygen Sensor High or Low Monitor - P0137, P0138, P0157, P0158
- 4.5.4 Downstream Oxygen Sensor Activity Check - P0140, P0160
- 4.5.5 Downstream Oxygen Sensor Response Check - P0139, P0159
- 4.6 Cooling System Monitoring
- 4.7 Positive Crankcase Ventilation (PCV) System Monitoring
- 4.8 Crankshaft Position Sensor
- 4.9 Camshaft Position Sensors
- 4.10 Camshaft Profile Switching (CPS) - Naturally Aspirated Engine Only
- 4.11 Cold Start Emission Reduction Monitoring
- 4.12 Idle Speed Control
- 4.13 Manifold Absolute Pressure Sensor
- 4.13.1 Schematic
- 4.13.2 High or low input failure - P0107, P0108, P0237 and P0238
- 4.13.3 Range or performance failure - P0106 (Naturally Aspirated Engine) and P0236 (Super Charged Engine)
- 4.13.4 Range or performance failure - P0106 (Super Charged Engine only)
- 4.13.5 Monitoring Structure
- 4.13.6 Drive Cycle Information
- 4.14 Mass Airflow Sensor
- 4.15 Barometric Pressure Sensor
- 4.16 Fuel Pressure System
- 4.18 Intake Air Temperature Sensor
- 4.19 Knock Sensor
- 4.20 ECM Power Supplies
- 4.21 Engine Control Module Self Test
- 4.22 Engine Starting
- 4.23 Accelerator Pedal Position Sensor
- 4.24 Throttle Control System
- 4.25 Torque Monitoring
- 4.26 Vehicle Speed Signal
- 4.27 Fuel Injectors
- 4.28 Ignition Amplifiers/Coils
- 4.29 Variable Valve Timing
- 4.30 Controller Area Network System
- 4.31 Fuel Level Sensor
- 4.32 Engine Off Timer
- 4.33 Ambient Air Temperature
- 4.34 Supercharger Intercooler Water Pump