Section 18 (Electronic Time & Alarm Control System (ETACS) - With Diagnostics - Lancer)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Special Tool
- Diagnosis
- Diagnostic Trouble Code Procedures
- DTC U0001: Bus off (CAN-C) DTC U0019: Bus off (CAN-B)
- DTC U0100: Engine control module CAN timeout
- DTC U0101: CVT-ECU/TC-SST-ECU CAN timeout
- DTC U0103: Shift lever CAN timeout
- DTC U0121: ASC-ECU CAN timeout
- DTC U0126: Steering wheel sensor CAN timeout
- DTC U0136: AWC-ECU CAN time-out
- DTC U0151: SRS-ECU CAN timeout
- DTC U0154: Occupant classification-ECU CAN timeout
- DTC U0155: Combination meter CAN timeout
- DTC U0164: A/C CAN timeout
- DTC U0168: WCM or KOS-ECU CAN timeout
- DTC U1108: Excess CAN-B ECU Detection
- DTC U1120: Bus line (CAN-C) low input DTC U1121: Bus line (CAN-C) high input
- DTC U0331: ECU internal error
- DTC B1761: VIN not recorded
- DTC B210A: +B power supply (low input); DTC B210B: +B power supply (high input)
- DTC B222C: Coding incomplete
- DTC B2206: Chassis number does not match
- DTC B2215: ECU internal error
- DTC B2353: Ignition power supply (low input); DTC B2354: Ignition power supply (high input)
- Data List Reference Table
- Trouble Symptom Chart
- Symptom Procedures
- Input Signal Procedures
- Inspection Procedure 1: ETACS-ECU does not receive any signal from the ignition switch (ACC)
- Inspection Procedure 2: Malfunction of the ignition switch (IG1) input/output signal
- Inspection Procedure 3: ETACS-ECU does not receive any signal from the key reminder switch
- Inspection Procedure 4: ETACS-ECU cannot receive the signal of front door lock actuator (LH) or front door lock actuator (RH)
- Inspection Procedure 5: ETACS-ECU does not receive any signal from the front door switch (LH)
- Inspection Procedure 6: ETACS-ECU does not receive any signal from the front door switch (RH)
- Inspection Procedure 7: ETACS-ECU does not receive any signal from the rear door switch (LH)
- Inspection Procedure 8: ETACS-ECU does not receive any signal from the rear door switch (RH)
- Inspection Procedure 9: ETACS-ECU does not receive any signal from the trunk lid actuator and switch. (LANCER)
- Inspection Procedure 9: ETACS-ECU does not receive any signal from the liftgate switch. (LANCER SPORTBACK)
- Inspection Procedure 10: ETACS-ECU does not receive any signal from the hazard warning light switch
- Inspection Procedure 11: ETACS-ECU does not receive any signal from the column switch signal
- Inspection Procedure 12: ETACS-ECU does not receive any signal from the hood latch switch
- On-Vehicle Service
- ETACS-Ecu