Section 11 (Basic Brake System - Lancer)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Service Specifications
- Lubricants
- Basic Brake System Diagnosis
- Introduction To Basic Brake System Diagnosis
- Basic Brake System Diagnostic Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Vehicle Pulls to One Side when Brakes are Applied
- INSPECTION PROCEDURE 2: Insufficient Braking Power
- INSPECTION PROCEDURE 3: Increased Pedal Stroke (Reduced Pedal-to-Floor Board Clearance)
- INSPECTION PROCEDURE 4: Brake Drag
- INSPECTION PROCEDURE 5: Scraping or Grinding Noise when Brakes are Applied
- INSPECTION PROCEDURE 6: Squealing, Groaning or Chattering Noise when Brakes are Applied
- INSPECTION PROCEDURE 7: Squealing Noise when Brakes are not Applied
- INSPECTION PROCEDURE 8: Groaning, Clicking or Rattling Noise when Brakes are not Applied
- Special Tool
- On-Vehicle Service
- Brake Pedal Check And Adjustment
- Brake Booster Operation Check
- Check Valve Operation Check
- Bleeding
- Brake Fluid Level Switch Check
- Brake Pad Check
- Brake Pad Replacement < Except RALLIART >
- Lubrication Point Brake Pad Replacement < RALLIART >
- Lubrication Point Brake Disc Check
- Brake Drag Force Check
- Brake Lining Thickness Check < Vehicles With Rear Drum Brake >
- BRAKE DRUM INSIDE DIAMETER CHECK < Vehicles with rear drum brake >
- BRAKE LINING AND BRAKE DRUM CONTACT CHECK < Vehicles with rear drum brake >
- Auto Adjuster Function Check < Vehicles With Rear Drum Brake >
- Brake Pedal
- Master Cylinder Assembly And Brake Booster Assembly
- Front Disc Brake Assembly
- Rear Disc Brake Assembly
- Rear Drum Brake