Section 51 (Combination Meter Assembly & Vehicle Speed Sensor)
WARNING: This page is about a different car, the 2004 Mitsubishi Galant. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Combination Meter Diagnosis
- Troubleshooting Strategy
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC U1073: Bus Off
- DTC U1100: Powertrain Control Module Time-Out (Related To Engine) DTC U1101: Powertrain Control Module Time-Out (Related To A/T)
- DTC U1102: Abs-Ecu Time-Out
- DTC U1109: ETACS-Ecu Time-Out
- DTC U1112: SRS-Ecu Time-Out
- DTC U1120: Failure Information On Powertrain Control Module (Related To Engine)
- DTC U1206: Flag Invalid
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Communication With Scan Tool Is Not Possible
- Inspection Procedure 2: Power Supply Circuit, Inspection Procedure 3: Odometer And Trip Meter Are Not Displayed, Inspection Procedure 4: All The Needle Meters Do Not Work Inspection Procedure 5: When The Ignition Switch Is Turned To The On Position, The Indicator And Warning Lights Do Not Illuminate
- Inspection Procedure 6: Speedometer Does Not Work, Inspection Procedure 7: The Fuel Gauge Needle Moves Excessively
- Inspection Procedure 8: Tachometer Does Not Work
- Inspection Procedure 9: Fuel Gauge Does Not Work (Other Meters Work)
- Inspection Procedure 10: Engine Coolant Temperature Gauge Does Not Work (Other Meters Work)
- Combination Meter Terminal Check
- Special Tools
- On-Vehicle Service
- Combination Meter Assembly And Vehicle Speed Sensor